A practical reference on Ac-LKKTETQ: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-08-08 and is reviewed periodically as new material appears.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Thymosin beta-4 is a naturally occurring protein of 43 amino acids found in most mammalian cells, where it binds actin monomers and influences filament dynamics. It was first isolated from thymus tissue in the early 1980s, and its actin-binding activity was later mapped to a short region near the N-terminus. The synthetic fragment sold as TB-500 was designed to reproduce that region rather than the full protein. Whether a short fragment reproduces the behavior of the intact molecule remains an open question, since the parent protein carries additional structural elements outside the binding region.
Published research on the intact protein is substantial, covering actin regulation, cell migration, and wound models. Research using the heptapeptide fragment specifically is far smaller, and much of the circulating material originates in supplier documentation rather than peer-reviewed reports. Where fragment studies do exist, they often employ different sequences, chain lengths, or terminal modifications, which complicates direct comparison across papers. Readers encountering claims about TB-500 should therefore separate evidence about thymosin beta-4 from evidence about the fragment itself.
Discussion of the compound frequently appears alongside other short peptides described as fragments of larger proteins. That grouping is convenient but can be misleading, because fragment length, charge, and modification state determine how a peptide behaves in solution and in any experimental system. A seven-residue acetylated peptide and a full-length protein differ in mass by roughly an order of magnitude, and they cannot be assumed to share distribution or binding properties. Precision about which molecule is under discussion is the single most useful step when reading such material.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Published work involving this sequence spans actin-binding assays, cell-migration studies, wound-healing models, and cardiovascular or musculoskeletal experiments. Much of the biological rationale derives from in vitro systems and animal models, and the number of controlled human studies is small. Reported outcomes vary across preparations, doses, and routes, which complicates comparison between studies. Reviews generally describe the evidence base as preliminary rather than settled. Mechanistic explanations are often proposed by analogy to the parent protein rather than demonstrated directly.
Dry peptide powder is commonly kept at −20 °C in a desiccated container away from light, a practice that limits moisture uptake and oxidation. Once dissolved, solutions are generally held at 2–8 °C for short periods or frozen at −20 °C or lower for longer storage, with repeated freeze-thaw cycles avoided. Hydrolysis and oxidation are the main degradation routes for peptides in solution, and both accelerate at higher temperature or extreme pH. Published stability data specific to TB-500 are limited, so shelf life should be treated as uncertain.
Identity and purity checks for peptide material typically combine reversed-phase high-performance liquid chromatography with mass measurement, since retention time alone cannot confirm a sequence. Mass measurement verifies the expected molecular mass within instrument tolerance, while chromatographic peak area provides a purity estimate. Anti-doping analysis of urine uses related but more sensitive workflows, sometimes after solid-phase extraction. For research material, batch documentation, certificate content, and independent testing are common points of scrutiny, because supply chains outside pharmaceutical regulation vary widely in the paperwork they provide.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Hirsutism is excessive body hair on parts of the body where hair is normally absent or minimal. The word is from the early 17th century: from Latin hirsutus meaning "hairy". It usually refers to a male pattern of hair growth in a female that may be a sign of a more serious medical condition, especially if it develops well after puberty. Cultural stigma against hirsutism can cause much psychological distress and social difficulty. Discrimination based on facial hirsutism often leads to the avoidance of social situations and to symptoms of anxiety and depression. Hirsutism is usually the result of an underlying endocrine imbalance, which may be adrenal, ovarian, or central. It can be caused by increased levels of androgen hormones. The amount and location of the hair is measured by a Ferriman–Gallwey score. It is different from hypertrichosis, which is excessive hair growth anywhere on the body. Treatments may include certain birth control pills, antiandrogens, or insulin sensitizers. Hirsutism affects between 5 and 15% of women across all ethnic backgrounds. Depending on the definition and the underlying data, approximately 40% of women have some degree of facial hair. About 10 to 15% of cases of hirsutism are idiopathic with no known cause.
The enzyme belongs to the family of transferases, to be specific those acyltransferases transferring groups other than aminoacyl groups. The systematic name of this enzyme class is malonyl-CoA:4-coumaroyl-CoA malonyltransferase (cyclizing, reducing).
and above a critical temperature, the self-assembly process will become progressively less likely to occur and spontaneous self-assembly will not happen. The self-assembly is governed by the normal processes of nucleation and growth. Small assemblies are formed because of their increased lifetime as the attractive interactions between the components lower the Gibbs free energy. As the assembly grows, the Gibbs free energy continues to decrease until the assembly becomes stable enough to last for a long period of time. The necessity of the self-assembly to be an equilibrium process is defined by the organization of the structure which requires non-ideal arrangements to be formed before the lowest energy configuration is found. Kinetics The ultimate driving force in self-assembly is energy minimization and the corresponding evolution towards equilibrium, but kinetic effects can also play a very strong role. These kinetic effects, such as trapping in metastable states, slow coarsening kinetics, and pathway-dependent assembly, are often viewed as complications to be overcome in, for example, the formation of block copolymers. Amphiphile self-assembly is an essential bottom-up approach of fabricating advanced functional materials. Self-assembled materials with desired structures are often obtained through thermodynamic control. Here, we demonstrate that the selection of kinetic pathways can lead to drastically different self-assembled structures, underlining the significance of kinetic control in self-assembly.
Deborah Kay Dunn-Walters FMedSci (born September 1963) is a British immunologist who is Professor of Immunology and Associate Dean for Research and Innovation at the University of Surrey. Her research considers B-cell development in healthy ageing and in disease, particularly from the viewpoint of antibody repertoires. During the COVID-19 pandemic, Dunn-Walters focussed on mapping responses to SARS-CoV-2 infection and the development of single cell analyses of the immunological responses to a COVID-19 vaccine. She was a member of the Scientific Advisory Group for Emergencies, and provided the government with scientific advice during the pandemic.
Sources: en.wikipedia.org
The Australian Radiation Protection and Nuclear Safety Agency (ARPANSA) is a regulatory agency under the Commonwealth of Australia that aims to protect Australian citizens from both ionising and non-ionising radiation. ARPANSA works under the guidance of the Australian Radiation Protection and Nuclear Safety Act of 1998 as the national regulatory body of radiation in Australia, with independent departments within each state and territory that regulate radiation within each of their jurisdictions. The Australian Radiation Protection and Nuclear Safety (ARPANS) Bill 1998 was passed by the Australian House of Representatives in May 1998, however Parliament was prorogued for the Federal Election (held 3 October 1998) before the Bill could be considered by the Senate. The Bill was reintroduced into Parliament in November 1998 and passed by both Houses of Parliament on Thursday 10 December 1998. ARPANSA's responsibilities include:
Radioactive substances can harm human health via (i) local skin contamination, (ii) internal exposure due to ingestion of radioactive isotopes, and (iii) external overexposure by β-activity and γ-radiation. Together with radium and transuranium elements, actinium is one of the most dangerous radioactive poisons with high specific α-activity. The most important feature of actinium is its ability to accumulate and remain in the surface layer of skeletons. At the initial stage of poisoning, actinium accumulates in the liver. Another danger of actinium is that it undergoes radioactive decay faster than being excreted. Adsorption from the digestive tract is much smaller (~0.05%) for actinium than radium. Protactinium in the body tends to accumulate in the kidneys and bones. The maximum safe dose of protactinium in the human body is 0.03 μCi that corresponds to 0.5 micrograms of 231Pa. This isotope, which might be present in the air as aerosol, is 2.5×108 times more toxic than hydrocyanic acid. Plutonium, when entering the body through air, food or blood (e.g. a wound), mostly settles in the lungs, liver and bones with only about 10% going to other organs, and remains there for decades. The long residence time of plutonium in the body is partly explained by its poor solubility in water. Some isotopes of plutonium emit ionizing α-radiation, which damages the surrounding cells.
Considering that stress-response proteins (like Hsp70) evolved before apoptotic machinery, Hsp70's direct role in inhibiting apoptosis provides an interesting evolutionary picture of how more recent (apoptotic) machinery accommodated previous machinery (Hsps), thus aligning the improved integrity of a cell's proteins with the improved chances of that particular cell's survival. In mice, exogenous recombinant human Hsp70 (eHsp70), delivered intranasally, increases lifespan. Although the maximum lifespan increased only moderately, the overall mortality rate in treated animals was much lower compared with the control group. Also this eHsp70-treatment improves learning and memory of mice in old age, increases their curiosity.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Most listings describe it as a short acetylated peptide with the sequence Ac-LKKTETQ, presented as a region of thymosin beta-4. The label is a trade-style name rather than a standardized chemical name, so the exact content of a given vial depends on the supplier.