A practical reference on thymosin beta-4: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2025-10-31. Anything still debated is marked as such rather than presented as settled.
TB-500 is a synthetic seven-residue peptide whose sequence, LKKTETQ, matches the N-terminal actin-binding region of thymosin beta-4. It is usually supplied in an N-terminally acetylated form, a modification that blocks the free amino terminus and can influence behavior in solution. In the research literature the same sequence appears under several names, including thymosin beta-4 fragment and shortened thymosin beta-4. Because it is a short peptide rather than the full 43-residue parent protein, its measured properties differ from those reported for thymosin beta-4 as a whole, and the two are not interchangeable in experimental design.
Thymosin beta-4 itself is a small, widely expressed protein that sequesters monomeric actin and participates in cell migration, angiogenesis, and tissue repair. Researchers have examined the shortened fragment as a possible mimic of some of these activities, reasoning that the actin-binding motif lies within the first few residues. Binding to monomeric actin has been observed in cell-free systems. Whether the fragment reproduces the broader effects of the full protein in living tissue remains an open question, and findings from animal models are frequently cited without a clear bridge to human physiology.
Discussion of TB-500 appears in several distinct literatures that rarely cite one another. Peer-reviewed studies usually describe in vitro assays or small animal experiments and are cautious about extrapolation. Veterinary and sports communities circulate anecdotal reports with limited methodological detail. Commercial listings add a third layer, often using the name interchangeably with thymosin beta-4 even though the two molecules differ in size and sequence. Regulatory status varies by country, and the compound is not a licensed medicine in most jurisdictions, so readers comparing sources should check which molecule and which purity each source actually describes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
| Property | Value | Notes |
|---|---|---|
| Molecular class | Synthetic peptide | N-terminal fragment of thymosin beta-4 |
| Residue count | Seven | Sequence LKKTETQ |
| Approximate mass | 889 Da | Acetylated seven-residue peptide |
| Common synonyms | TB4 fragment, TB500 | Not identical to full-length TB4 |
| Reported activity | Actin binding | Observed mainly in cell-free systems |
Lyophilized peptide powder is normally held desiccated at −20 °C, with −80 °C used for longer storage periods. Allowing a sealed vial to reach room temperature before opening is standard practice, because condensation forming on cold powder introduces moisture. Once dissolved, solutions are typically kept cold and shielded from light. Repeated freeze-thaw cycles are avoided because they encourage aggregation and gradual loss of material. These conventions are general to synthetic peptides rather than unique to any one sequence.
Purity and identity are separate measurements and are often confused. Reverse-phase high-performance liquid chromatography, usually with ultraviolet detection near 214 nanometres, reports the share of total peak area belonging to the target compound. Mass spectrometry by electrospray or matrix-assisted laser desorption then checks whether the observed mass matches the expected sequence. Neither measurement alone shows that a vial holds the intended peptide. Peptide content, meaning the fraction of vial mass that is genuine peptide rather than counter-ion, water or residual acid, is reported separately and is frequently lower than the stated purity figure.
The regulatory position is broadly consistent across major jurisdictions: no thymosin beta-4 fragment is an approved medicine, and laboratory material is commonly labelled as not intended for human consumption. Anti-doping rules in sport list thymosin beta-4 and its fragments among prohibited peptide hormones. Because these products travel through research-chemical channels rather than pharmaceutical supply chains, quality varies considerably between vendors. Independent testing of identity, purity and sterility is the only dependable check, and a certificate of analysis describes one batch rather than a supplier's whole catalogue.
Lyophilised peptide is normally reconstituted with sterile water or a neutral buffer shortly before use. Because repeated freeze-thaw cycles can degrade the material, dividing a reconstituted solution into single-use aliquots is a common practice. Working solutions are usually kept cold and protected from light. The exact shelf life depends on concentration, buffer composition, and handling, so it is often determined empirically rather than assumed.
Peptide bonds are susceptible to hydrolysis under extreme pH and to enzymatic cleavage if proteases are present. Heat, oxidising agents, and prolonged exposure to light also contribute to loss of material. Aggregation can occur at high concentrations or in certain buffer systems, and it may not be visible to the eye. Storage at -20 C or below is typical for both powder and aliquoted solutions, and desiccation of the powder is preferred.
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography together with mass spectrometry. The chromatogram provides a purity estimate as a percentage of total peak area, while the mass spectrum confirms that the observed mass matches the expected value. Amino acid analysis or tandem mass spectrometry sequencing can provide additional confirmation. Reported purity figures depend on the column, gradient, and detection wavelength, so values from different laboratories are not directly comparable without method details.
[PtCl4]2- + 2 H2NCH(R)CO2− → [Pt(H2NCH(R)CO2)2] + 4 Cl− Relevant to bioinorganic chemistry, amino acid complexes can be generated by the hydrolysis of amino acid esters and amides (en = ethylenediamine):
== Adverse effects == Adverse effects include peritonitis, respiratory infection, hypertension (high blood pressure), rashes, and headache. Of these side effects, only hypertension and rashes occurred significantly more often than under glucose solution; the other events seem to be related to peritoneal dialysis in general.
Protein Structure drugdesign.org [1] Method_for_the_Characterization_of_the_Three-Dimensional_Structure_of_Proteins_Employing_Mass_Spectrometric_Analysis_and_Experimental-Computational_Feedback_Modeling [2] A_Method_for_the_Determination_of_the_Conformation_(Topology)_of_Proteins_Employing_Experimental-Computational_Feedback_Modeling
=== Isothermal–isobaric (NPT) ensemble === In the isothermal–isobaric ensemble, amount of substance (N), pressure (P) and temperature (T) are conserved. In addition to a thermostat, a barostat is needed. It corresponds most closely to laboratory conditions with a flask open to ambient temperature and pressure. In the simulation of biological membranes, isotropic pressure control is not appropriate. For lipid bilayers, pressure control occurs under constant membrane area (NPAT) or constant surface tension "gamma" (NPγT).
Sources: en.wikipedia.org
=== Nomenclature === Often amide refers to carboxamide, and often amide refers to the anions R2N- and their derivatives. Tetrakis(dimethylamido)titanium (Ti(N(CH3)2)4) illustrates the ambiguity of the terminology.
== Properties == The properties of a material in nanoparticle form are unusually different from those of the bulk one even when divided into micrometer-size particles. Many of them arise from spatial confinement of sub-atomic particles (i.e. electrons, protons, photons) and electric fields around these particles. The large surface to volume ratio is also significant factor at this scale.
== Pokeweed antiviral protein == Pokeweed antiviral protein is a ribosome inactivating protein that provides pokeweed plants protection against both viral and fungal infections. It also protects other types of plants that have genetically engineered to express RAP that do not normally do so. Recombinant pokeweed antiviral protein has also been proposed as a treatment of human diseases such as AIDS and cancer.
Sources: en.wikipedia.org
No. Thymosin beta-4 is a 43-residue protein, while TB-500 refers to a seven-residue fragment corresponding to its N-terminal region. The two names are often used loosely in commercial and community writing, which obscures the difference in size, sequence, and likely behavior.
The fragment contains an actin-binding motif, and cell-free experiments show that it can interact with monomeric actin. That observation is the basis for interest in cell migration and repair processes. Effects reported in animals are not established for humans.
Purity is usually stated by the supplier rather than fixed by a pharmacopoeial monograph, and typical listings report a percentage from reverse-phase HPLC. Independent verification is uncommon. Because no single accepted specification exists, comparisons between lots and between suppliers are difficult.
No. Thymosin beta-4 is a 43-residue protein, while TB-500 matches only residues 17 to 23 of that chain. The two are related but differ in size, and a method that identifies one does not automatically identify the other.